Dr. Sat discussion forum
Television sources => Free to Air (FTA) Satelilte Television => Topic started by: tundelas on September 13, 2014, 04:48 pm
-
Two quick questions:
1) A channel has moved from DVB-S to DVB-S2. Will a DVB-S receiver still be able to receive signal from the satellite? (I'm trying to point a dish, but can't seem to catch it.. is it because the receiver I'm using is DVBS?)
2) How do I find out what elevation I have my satellite at? The back of the dish is very very rusted and the small numbers indicating elevation cannot be seen anymore. What's the best way to tell what my elevation is set to?
Thanks.
-
A legacy satellite receiver that only supports DVB-S can't tune any DVB-S2 transponders so you won't see any quality levels when trying to tune those. However, you may still use any other active DVB-S transponder on the same satellite in order to tune your dish using that receiver.
If the elevation scale on your dish is gone you may use an inclometer in order to measure your dish's elevation. This can be purchased at any hardware store
-
An inclinometer will be accurate with a prime focus dish.
However if you place the inclinometer on the face of an offset dish then the reading will be off by the amount of the dish offset, usually 22 to 25 degrees.
-
1) A channel has moved from DVB-S to DVB-S2. Will a DVB-S receiver still be able to receive signal from the satellite? (I'm trying to point a dish, but can't seem to catch it.. is it because the receiver I'm using is DVBS?)
DVB-S receiver can detect a DVB-S2 signal. The issue is that it can not decode the signal. (on a DVB-S receiver a signal will jump back and forth. one sec 90 then 2 then 35 then 0, etc).
Use a DVB-S2 receiver to find the signal. Make the BIOS is set correctly. Error in the BIOS will prevent you from using default setting commonly found on line.
2) How do I find out what elevation I have my satellite at? The back of the dish is very very rusted and the small numbers indicating elevation cannot be seen anymore. What's the best way to tell what my elevation is set to?
There are many sites that give you a reasonable elevation values. Its probably best to use one of them as a start point.
BTW. if the dish was left alone. You still may be in alignment with that satellite.
Good Luck,
EB
-
DVB-S receiver can detect a DVB-S2 signal. The issue is that it can not decode the signal. (on a DVB-S receiver a signal will jump back and forth. one sec 90 then 2 then 35 then 0, etc).
Although some DVB-S receivers may have a signal meter that responds quick enough to jump back and forth on a DVB-S2 signal, many DVB-S only receivers simply won't show any signal quality when trying to tune a DVB-S2 transponder.